Courses:

Introduction to Numerical Simulation (SMA 5211) >> Content Detail



Assignments



Assignments

MATLAB® software is required to run the .m files in this section. The .ckt, .sys, and .qif files in this section are MATLAB® input files used in the assignments.

ASSIGNMENTS       SUPPORTING FILES
Problem Set 1 (PDF)loadmatrix.m (M), readckt.m (M), readelement.m (M), test.ckt (CKT), test2.ckt (CKT), test3.ckt (CKT)
Problem Set 2 (PDF)qr_.m (M)
Problem Set 3 (PDF)qr_.m (M)
Problem Set 4 (PDF)pois2d.m (M), sgcr.m (M), tgcr.m (M)
Problem Set 5 (PDF)
Problem Set 6 (PDF)force.m (M), loadnewton.m (M), newton.m (M), readjoint.m (M), readload.m (M), readsystem.m (M), test1.sys (SYS), test2.sys (SYS), test3.sys (SYS), test4.sys (SYS), test5.sys (SYS), test6.sys (SYS), test7.sys (SYS), test8.sys (SYS), test9.sys (SYS), test10.sys (SYS), test11.sys (SYS)
Problem Set 7 (PDF)
Problem Set 8 (PDF)calccap.m (M), calcp.m (M), collocation.m (M), gencolloc.m (M), plate144.qif (QIF), plate36.qif (QIF), plate9.qif (QIF), plotpanels.m (M), readpanel.m (M), readpanels.m (M), sphere192.qif (QIF), sphere48.qif (QIF), sphere768.qif (QIF)

Moldy molecular dynamics program


 








© 2010-2017 OpenHigherEd.com, All Rights Reserved.
Open Higher Ed ® is a registered trademark of AmeriCareers LLC.